P0128 on a 2015 Ford Fusion

P0128 means the engine warmed up slower than expected or stayed cooler than the computer expected.

Not your vehicle? See general P0128 info.

Most common causes on the 2015 Ford Fusion

Ranked from 1,049 NHTSA owner complaints filed for this vehicle.

Sort by:

1
Low coolant level from chronic coolant loss (1.5L EcoBoost head-gasket/block coolant-intrusion defect)
High severity
Repeated reports of the coolant reservoir running dry or needing frequent top-offs, low-coolant warning lights, and coolant loss with no visible external leak; insufficient coolant volume prevents the engine from reaching/holding its regulating temperature.
Reported in 12 NHTSA complaints
2
Erratic/failed engine coolant temperature (ECT) sensor
Medium severity
One owner's overheating warning light was traced to a failed engine sensor that was replaced but the fault recurred, consistent with an unreliable ECT signal.
Reported in 1 NHTSA complaint
Parts:engine coolant temperature sensor
3
Stuck-open thermostat
Medium severity
A thermostat that fails to close lets coolant circulate continuously through the radiator, keeping engine temperature below the regulating point.
Common cause
Parts:thermostat
4
Cooling fan stuck running continuously
Low severity
A fan relay or fan control module fault that keeps the electric fan on over-cools the engine even at operating temperature.
Common cause
Parts:cooling fan assembly fan control module
5
Air pocket in the cooling system after a coolant top-off or repair
Low severity
Trapped air prevents the ECT sensor from reading true coolant temperature until the system is properly bled, common on this vehicle given the frequent coolant refills reported.
Common cause
6
Corroded or damaged ECT sensor wiring/connector
Low severity
Poor connector contact biases the sensor signal toward a low-temperature reading; inspect and clean the connector before replacing the sensor.
Common cause

Part links go to Amazon search results for this vehicle. As an Amazon Associate, WrenchConnect earns from qualifying purchases — always confirm fitment for your exact trim and engine before ordering.

These causes are aggregated from NHTSA owner complaints and general repair knowledge — this is not a diagnosis. P0128 on your car still needs shop confirmation before any repair.

Common symptoms

Check engine light
Weak cabin heat
Poor fuel economy
Temperature gauge low
Long warm-up time

What to check before replacing parts

Check coolant level when the engine is cold

Look for: Low coolant reduces the system's ability to reach and hold operating temperature — top off and recheck before assuming the thermostat or sensor is at fault.

Compare scan-tool coolant temperature to actual warm-up time

Look for: An engine that takes noticeably longer than normal to reach operating temperature (or never gets there) on the scan tool, with normal coolant level, points to the thermostat rather than the sensor.

Inspect thermostat operation

Look for: A thermostat stuck open (or opening at the wrong temperature) lets coolant circulate through the radiator too early, keeping the engine running cooler than it should — this is the most common cause of this code.

Check cooling fan command

Look for: A fan that runs constantly or turns on too early (commanded on when temperature is still low) keeps the engine from warming up normally, mimicking a stuck-open thermostat.

Inspect coolant temperature sensor data

Look for: A sensor reading that doesn't rise smoothly with actual engine warm-up, or that reads implausibly low compared to how the engine feels/behaves, points to a sensor or wiring fault rather than a true cooling problem.

Rather have a pro handle it? Find a vetted local mechanic.