P0420 on a 2015 Jeep Wrangler

P0420 means the downstream oxygen sensor pattern suggests the bank 1 catalytic converter is not storing oxygen properly.

Not your vehicle? See general P0420 info.

Most common causes on the 2015 Jeep Wrangler

Ranked from 456 NHTSA owner complaints filed for this vehicle.

Sort by:

1
Chronic cylinder misfire from 3.6L Pentastar valvetrain wear ('Pentastar tick') or defective cylinder-head repairs
High severity
An unusually large share of this vehicle's complaints describe recurring cylinder misfires (cyl #1/2/4/6), ticking lifters/rocker arms, and known FCA powertrain-warranty extensions for cylinder-head replacement; sustained misfire dumps raw fuel into the exhaust and overheats/melts the converter.
Reported in 14 NHTSA complaints
Parts:catalytic converter ignition coil cylinder head
2
Head gasket failure allowing coolant/oil intrusion into a cylinder
High severity
One owner's engine suffered a blown head gasket alongside a broken exhaust valve spring and cracked oil filter housing; coolant or oil burned through the cylinder contaminates and fouls the catalyst.
Reported in 1 NHTSA complaint
Parts:head gasket catalytic converter
3
Worn or aged catalytic converter
Medium severity
Normal high-mileage degradation of the substrate reduces conversion efficiency below the OBD2 threshold independent of any other fault.
Common cause
Parts:catalytic converter
4
Failed downstream oxygen sensor
Medium severity
A slow or biased rear O2 sensor can make the PCM flag the converter as inefficient even when it's fine.
Common cause
Parts:oxygen sensor
5
Exhaust leak ahead of the downstream sensor
Medium severity
A leaking manifold gasket or cracked pipe lets outside air skew the sensor reading used to judge cat efficiency.
Common cause
Parts:exhaust manifold gasket
6
Oil consumption from worn valve seals fouling the converter
Medium severity
Gradual oil burning through worn valve guides/seals coats the catalyst and reduces its efficiency over time.
Common cause

Part links go to Amazon search results for this vehicle. As an Amazon Associate, WrenchConnect earns from qualifying purchases — always confirm fitment for your exact trim and engine before ordering.

These causes are aggregated from NHTSA owner complaints and general repair knowledge — this is not a diagnosis. P0420 on your car still needs shop confirmation before any repair.

Common symptoms

Check engine light
Usually no drivability issue
Failed emissions test
Sulfur smell in some cases
Reduced power if converter is clogged

What to check before replacing parts

Check for misfire and fuel trim codes first

Look for: Any active or recent misfire, or lean/rich trim codes, means raw fuel or an off mixture has likely already damaged or is currently overworking the converter — fix those before touching the catalyst.

Inspect for exhaust leaks ahead of the converter

Look for: A leak before the converter (cracked manifold, loose flange, blown gasket) lets in outside air that confuses the downstream O2 sensor into reading as if the catalyst isn't working, even when it is.

Compare upstream and downstream O2 sensor activity

Look for: A healthy converter makes the downstream sensor read flat and steady while the upstream sensor swings actively. If the downstream sensor switches nearly as fast as the upstream one, the converter isn't storing oxygen properly and is likely worn out.

Check converter temperature and performance

Look for: A converter outlet noticeably cooler than expected relative to its inlet under load suggests little catalytic reaction is happening inside — supports a genuinely failed converter rather than a false reading.

Hold off on replacing the converter until root causes are ruled out

Look for: If misfires, exhaust leaks, or fuel trim issues caused this code, a new converter will fail again quickly — confirm those are clean first.

Rather have a pro handle it? Find a vetted local mechanic.

Matching symptoms

Check Engine Light